Quality Products, Professional Advice, Expert Repairs. For all of your floorcare needs!
6487 N. Blackstone Ave.
1834 Fulton Ave.
(559) 449-8258 (916) 481-4860


Vacuum Repairs and Services

Vacuum Repairs - Our factory certified and trained technicians offer you the peace of mind knowing the job will be done right... the first time. As our customer, your satisfaction is our highest priority. We have been servicing the Fresno community for more than 20 years as well as the Sacramento community for more than 30 years. All of our repair work is completed on site using the latest technologies. With down home, old fashion customer service, we pride ourselves in providing quality, affordable, and fast service so that we can not only meet your expectations, but exceed them. So, if you want to get it done right the first time...bring it to Beal's!

Vacuum Services - The overall appearance of your carpet depends on a good vacuum cleaner. Without it, your carpet nap will start getting matted and packed down from foot traffic. Dark colored traffic trails begin to appear. As the sand and dirt build up, it acts like sandpaper, slowly wearing and cutting the fibers as you walk across the carpet. As dirt, dust, and lint pass through your vacuum cleaner, a buildup in the bearing housings and bearings will slow down the brush roll causing excessive wear on your vacuum motor and belt. Over a period of time some brushes become soft, lose effectiveness and need to be replaced. A worn out brush may still look completely fine. If not replaced, it will simply turn, never touching the carpet, thus cutting your cleaning effectiveness by as much as 50 percent. Additionally, accumulated dirt and dust in the motor bearings will slow down the motor resulting in an overheated motor which can dramatically shorten the life of a vacuum motor or even require a total replacement of the entire vacuum.

So, don't wait until your vacuum starts performing poorly, the beauty and longevity of your carpet, upholstery, and floors depend on you bringing it to Beal's.

Beal's 15 Point Complete Service

  1. Check belt - Replace if necessary.
  2. Check agitator brushes - Replace if necessary
  3. Disassemble, clean, and grease agitator
  4. Check electrical system
  5. Disassemble motor
  6. Check outer bag, if applicable
  7. Check motor bearings, if necessary
  8. Clean & grease motor bearings, if necessary
  9. Check motor brushes
  10. Check armature and field
  11. Check the motor's fan system
  12. Lube all moving parts
  13. Clean unit's interior and exterior in sink with de-greaser
  14. Bench test
  15. Replace paper bag and/or primary filter, if necessary